Easy assembly · no power tools

Work bench assembly instructions

Each work bench stands on two upright end frames joined by beams and steel panels. Each frame bolts together on the floor in a few minutes. Watch the build sequence below, then follow the written steps.

Step 1 of 8
Lay out the two uprights
Both end frames ready beams and steel panels go between them
Uprights Top & bottom braces Diagonal brace Bolt points Beams Steel panels

Every work bench has two end frames — build both the same way, then slot in the beams and steel panels.

Step by step

  1. Lay out the uprights. Place the two uprights flat on the floor, side by side and about the bench depth apart, with the foot plates at the same end. Working on the floor is much easier than holding the uprights standing.
  2. Bolt on the top brace. Slot one end of a straight brace into the top of each upright. Line up the pre-drilled holes, push a bolt through and fit a nut on the far side. Keep the bolts finger-tight for now.
  3. Bolt on the bottom brace. Fit the second straight brace near the foot plates the same way — line up the holes, bolt through, nut on the far side.
  4. Add the diagonal brace. Run the diagonal from just under the top brace on one upright down to just above the bottom brace on the other. Line up the holes and bolt both ends.
  5. Square up and tighten. Check the frame sits square and flat, then tighten all bolts firmly with the supplied Allen key. One end frame is done.
  6. Build the second frame and stand both. Repeat steps 1–5 for the second end frame. Stand both frames upright and parallel, the bench length apart.
  7. Slot in the beams. Choose the height you want for each level. Slot the beams into the uprights at that height — one at the front and one at the back of each level — and push down firmly so each beam sits fully in its slots.
  8. Slot in the steel panels. Drop the steel panels onto the beams at each level and press down until they sit flat. Your work bench is ready to use.

What you'll need

  • The supplied Allen key
  • The supplied bolts and nuts
  • A flat, level floor
  • Two people to stand the frames

Tips

  • Keep the foot plates at the same end on both uprights
  • Leave bolts finger-tight until the frame is square
  • Build both end frames before standing them up
  • Start the beams from the lowest level
  • The frame is bolted, not welded — it comes apart the same way
Safety: Tighten every bolt before loading the bench. Spread weight evenly and do not exceed the rated load shown on your work bench page.

Prefer to watch? Watch the work bench assembly video