How to Fix a Loose or Misaligned Cabinet Door
A Practical Fix-It Guide · No. 40
A door that won't sit straight makes a whole cabinet look neglected.
Over time, a display cabinet door can start to sag, rub against the frame, or refuse to close flush. Usually it isn't damage — it's a hinge that has worked slightly loose, or an alignment that has drifted a millimetre or two. Both are quick to put right with a screwdriver and a few minutes, no parts required.
This guide walks through diagnosing the cause and correcting it, step by step — from tightening a loose hinge to squaring up a door that closes crooked.
First, find the cause
Open and close the door slowly and watch where it goes wrong:
- Door drops or sags at the outer edge — a hinge screw has loosened, or the hinge itself needs adjusting.
- Door rubs the frame on one side — it's sitting too far over; the hinge position needs a small sideways adjustment.
- Door won't close flush or springs back — it's sitting proud; the hinge depth or the magnetic catch needs setting.
- Handle or knob turns loosely — that's the fixing screw behind it, not the hinge.
Fixing a loose hinge
The most common cause. With the door open, look at the hinges top and bottom and find the mounting screws holding each hinge to the frame.
Hold the door or have a second person steady it, so it doesn't drop further while the screws are loose.
Turn each hinge screw clockwise until snug. Firm is enough — over-tightening can strip the thread in an aluminium frame. Do the top hinge first, then the bottom.
Close the door and check the gap down the edge is even. If a screw just spins and won't bite, the hole has worn — see the tip below.
Squaring up a misaligned door
If the door is tight but sits crooked — rubbing one side or leaning — the fix is to shift it slightly at the hinge. Many cabinet hinges have a little play in the screw holes for exactly this.
Loosen (don't remove) the hinge screws just enough that the hinge can move a hair. Nudge the door into square so the gap down the opening edge is even top to bottom, then re-tighten while holding it in place. Adjust one hinge at a time and re-check after each — small moves make a big difference.
If the door still won't close flush, check the magnetic catch or strike plate: it may have loosened or shifted. Line the catch up with the plate on the door and tighten it so the two meet cleanly.
A screw that spins freely means the hole has worn. Back it out, and either move to a fresh fixing point a few millimetres over, or step up one screw size so it grips new material. Don't keep forcing the old hole — it only widens it further.
When to call us instead
Most sagging and rubbing is a two-minute hinge adjustment. But if a hinge is cracked, a glass door is chipped at the fixing, or the frame itself has flexed out of square, stop and talk to us before forcing anything — glass under tension can break. We can supply replacement hinges and catches, and talk you through the fit.
Need a hinge, catch, or a hand?
We supply, deliver, and install across Perth and Australia-wide. Call us on 08 6237 1039, or visit us at 325 Victoria Road, Malaga WA 6090 — Mon–Fri 9am–5pm, Sat 10am–2pm AWST.